ADIA Service & Maintenance Final Mock Quiz

What is the most important task to carry out before commencing work?

To ensure that the door is working correctly before you start the service, you should?

For safe working, you should ensure that –

Which parts of the door system should be lubricated?

A build-up of dust in a safety sensor will result in?

Some manufacturers recommend that a drive belt is changed every –

To keep the bottom of a sliding door in alignment, which of the following is fitted –

When a drive arm is installed on a swing door, to ensure that the door is kept in the closed position, it should always be –

On a sliding door, the purpose of the counter rollers is to –

When should you replace a floor guide?

On a swing door, a pivot is fitted to keep the door at the correct –

The gaps around any door leaf should be –

When checking the door alignment, you should also check –

If the door alignment is adjusted then you should ensure –

End stops are fitted on a sliding door to ensure this position –

To ensure that the operator is securely fixed, you should –

Wiring should be secured and tidy to ensure that –

On a sliding door, if you found that the distance between the door and the frame was less than 25mm, you would –

When cleaning the sensors during a service, you must not use –

Which of the following will determine whether you can safely refit the cover to the operator?

When refitting covers to sensors, care must be taken to ensure that –

To ensure that the operator is protected, which of the following is correct?

To determine whether you can safely remove the cover on an operator, you should carry out a –

When carrying out the checklist, you are testing the door to which of the following standards?

Which of the following tools are used to test an automatic door?

The serial number of the automatic door should be on the operator and also within the –

The usable aperture that a person can walk through is known as?

The time that the door stands at the open position before it starts to close, is known as?

On a swing door, what consideration must be taken into account when measuring the activation distance on the opening side?

To reduce the risk of drawing in, shearing or crushing, the distances required are?

Which of the following is used to test an ESPE safety sensor?

When testing an ESPE safety sensor, at what distance should the test body be detected?

When placing the test body within the door area, you are assessing the risk of which of the following?

When testing the closing energies of an automatic door, you should hold your newton meter at what height?

On an automatic door, the maximum permitted closing energy force you should measure is less than?

At between what heights should signage be fitted?

After what year would you apply the EN16005 to an installation?

The responsibility for the display of any signage on an automatic door is the –

If breakout is fitted, the maximum required to force the door open is?

To measure the force to open an automatic swing door with your Newton Meter, the door must be in which position?

In the event of a power failure and if a fail-safe is fitted then the door could adopt which of the following positions?

Which of the following best describes the purpose of the Checklist?

If the programme switch has a locked position, then it should –

What is the minimum requirement for servicing an automatic door?

When should your Newton Meter force gauge be calibrated?

Why would you erect safety barriers when working on an automatic door?

If your found a risk on an automatic door what should you do?

If you test a door ESPE safety sensor and find that the CA test body is detected at 150mm then the test is a?

There is a risk of crushing at the hinge point of an automatic door, what should you recommend?